• 0 Points
  • Member since 2007

  • Chatter
  • 0
    Best Answers
  • 0
    Likes Received
  • 0
    Likes Given
  • 1
  • 0
Hi, I am reasonably new to the Connector but am having some success thanks to the doc I have found. When I manually fill in key fields in a row, highlight and do the Insert, all goes well. But when I change a cell and highlight just the row, then do the Update, I get an error message about
 "selection too large, cannot run on > 3500 rows > 20 cells"
even if I highlight only the target row from the right at the end of the Sf columns to the left. Any ideas? Thanks, JJM (I hope this goes to the Connector page and not Introduce page again)
  • March 14, 2007
  • Like
  • 0